Two AC outlets
The main output has the “no-break” function (without interruption). The MultiPlus takes over the supply to the connected loads in the event of a blackout or disconnection from the mains/generator.
The second output is only active when AC power is supplied to one of the MultiPlus inputs. Appliances that should not discharge the battery can be connected to this output, such as a water heater, for example (second output available only on models with a 50A transfer switch).
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can work in parallel to achieve higher power output and charging.
Three-phase operation capacity
In addition to parallel connection, three units of the same model can be configured for three-phase output. But that's not all: up to 6 sets of three units can be connected in parallel.
PowerControl – Limited power from generator, dock or grid
The Multi is a very powerful battery charger. Therefore, it will use a lot of current from the generator or from the dock mains (almost 10 A for each 5kVA Multi at 230 VAC). In the Multi Control Panel, a maximum current coming from the generator or from the dock can be established. The MultiPlus will take into account the other AC loads and will use the excess current for the load, thus avoiding overloading the generator or the pontoon network.
